Home > Dodge Ram > Dodge Ram Blower Fan Not Working

Dodge Ram Blower Fan Not Working

Contents

If you pop the top cover off the steering column right behind the steering wheel tilt lever on the left is a black box that the main connector plugs into. It's cold outside... Working... Jake Payne 69,328 views 1:51 2002 DODGE RAM 1500 increases mileage by 50% - Duration: 2:29. http://sevevb.com/dodge-ram/dodge-ram-1500-blower-not-working.html

Help!! Is this from that wire harness in the steering column? 94 today wish I had air LOL! Once they are cut, strip the ends of all 3 about 3/8" and slide heat shrink down the wires. Loading... https://www.cargurus.com/Cars/Discussion-t21939_ds615899

Dodge Ram Blower Motor Not Working

Ram - All Topics Performance and Accessories 2nd gen only 24 Valve Engine and Drivetrain 12 Valve Engine and Drivetrain 2nd Gen. Mark helpful 0 Report tml61747 answered about a week ago Relay is under glove box and is visible by just getting under it looking for a white resistor. Bit different. Sign in Transcript Statistics 55,041 views 281 Like this video?

I have tried to figure out how to tear the dash apart to get the switch and have not been able to figure that out and have been told there is They're prone to this problem, and if there is any damage, the connector can be replaced. With the power on and the blower switch on wiggle it around to see if it comes on. 2002 Dodge Ram 1500 Blower Motor Not Working Thanks for the help!

Thanks. Color: Bright White Rep Power: 18 Rep:2078 Welcome to RamForumZ!!! Fan shut off, fan came on, approx 1 minute later fan shut off, 2 minutes later fan came on...did this about 5 times until it didn't come back on again.

Now cut the 10 AWG into two equal pieces and strip one end of each back about 3/8".

CarGurus | My account Saved searches Saved listings Saved promotions Sign in Join | Advertise | United States Canada United Kingdom Used Cars New Cars Car Values Sell My Car 2004 Dodge Ram Blower Motor Not Working Run the tap into both holes until it bottoms out, but don't get crazy with it and break the tap off! It should slide off and with a little effort, and you may want to pull it slightly outward while back. 2) Next you will need to remove the top and bottom You currently have 0 posts.

  • Now push the red slide connector back over at the bottom.
  • Here's the schematic for the blower resistor.
  • Slide the heat shrink back up, centered over the connector, and shrink it with a heat gun. 5) Now you want to strip back the green and pink wires about 3/8".
  • It won't go and won't shift when it does go.

Dodge Ram Blower Motor Intermittent

Have no idea what the part is called so I am hoping someone can tell me, that way I can get it and replace it. http://www.dieseltruckresource.com/forums/3rd-generation-ram-non-drivetrain-all-years-101/blower-fan-wont-work-258135/ Now you should put the key in the ignition and run a function test by turning it back and making sure the accessories have power, then back to off, then on Dodge Ram Blower Motor Not Working Watch QueueQueueWatch QueueQueue Remove allDisconnect Loading... 2003 Dodge Ram Blower Motor Not Working Now you want to use the female spade terminals, with the 10 AWG wire using the yellows and the 18 AWG switch wire using the blue connector.

Please enable cookies. http://sevevb.com/dodge-ram/dodge-4x4-not-working.html I've got a good ground from the blower motor control switch. Isaac Farias 129,075 views 14:53 2004 Dodge Ram 1500 ignition swap - Duration: 10:42. Sign in to make your opinion count. 2006 Dodge Ram Blower Motor Problems

Dodge Cummins 03-07 Common Rail Forums > 3rd Gen. Thread Tools #1 12-07-2009, 03:04 PM Kim Dodge Ram Forum Newcomer Join Date: Dec 2009 Location: Sedgewick Alberta Age: 62 Posts: 1 Gender: Male Vehicle: 07 Dodge 3500 not enough to cool anyone off by any means, but it is thare. his comment is here I live in the desert and it is aa nasty mother here now so some A/C would be great!

This happens to be the case with the wiring harness as well, but the heater fan switch works again just fine. 2008 Dodge Ram Blower Motor Not Working Also, is this a common problem for these trucks? Could that be a symptom of a bad blower motor resistor?

Mark helpful 100 Report rowdyraven answered 11 months ago I replaced the ignition switch and that seems to have worked!!! 3 out of 3 people think this is helpful.

Musher Deeds 30,331 views 3:09 2001 Dodge Durango blower motor, A/C troubleshooting - Duration: 9:19. Sign in 282 7 Don't like this video? Non-Powertrain > DIY fix for intermittent or no blower fan control Reply Page 1 of 3 1 23 Tweet LinkBack Thread Tools Display Modes post #1 of 29 (permalink) 2007 Dodge Ram Blower Motor Not Working Thanks for the tip.

exhaust manifold. Really easy to see if the grease has turned green and the contacts are all brass, so you just need to clean well and regrease. I stil don't know exactly where the problem lies, but I'm eliminating things. weblink YouBulkit 90,688 views 4:50 How To: Replace A/C Condenser Fan on a Dodge Ram PickUp - Duration: 13:18.

This feature is not available right now. Fan shut off, fan came on, approx 1 minute later fan shut off, 2 minutes later fan came on...did this about 8 times a day until it didn't come back on Lol. Yesterday 08:37 PM by WalterG 0 05 Grand Caravan,...

One more step Please complete the security check to access www.justanswer.com Why do I have to complete a CAPTCHA? If I pull up on the box my fan kicks in once I let go it shuts off. Battery Geek 143,358 views 7:45 2006 dodge ram 2500 ignition switch replacement - Duration: 6:37. Mark helpful 57,415 Report T_S_T answered 2 years ago I think it can be ohmed,if you have ohm meter,you can all so test,by cutting blower on,and check for fire at it.if

The only thing that matters is if your local dealer runs your VIN through their system and finds an open recall specific to your vehicle. New to the forums? OK, will try that later. John vetthc72Jul 31, 2011, 08:48 AMThanks sixscrews I had the same problem in my 2003 Dodge Ram.